Melbourne is two different places for a pool owner. On the barrier island you get ocean wind and salt on everything. On the mainland you get lagoon moisture, mature oaks and a lot of older screened pools. We start every conversation by asking which one you live in, because it changes the plan for a new pool or a tired finish that needs resurfacing.
Local notes for pools in Melbourne
Barrier island or mainland
Melbourne sits on both sides of the Indian River Lagoon. Homes on the barrier island strip, including the separate beach towns of Indialantic, Melbourne Beach and Satellite Beach, take ocean wind and salt on every surface. Mainland neighborhoods are a little more sheltered, but lagoon-front lots share the same moisture. We ask which side you are on at the first call, because it changes equipment choices, how we protect metal parts, and which building office handles your permit.
Salt air and your equipment
Salt air eats unprotected metal. Heater cabinets, pump housings, ladder anchors, handrails and screen frames show rust sooner near the water. When we write an estimate we note where corrosion-resistant parts, coated fasteners and a sheltered equipment pad make sense. If you already see rust streaks near the pad or stained deck below a ladder, that is worth a look through pool repair in Melbourne before it turns into a failed part.
Screen enclosures and coastal wind
Many Melbourne pools sit under a screened enclosure, and a new pool does not come with one automatically. Enclosures are built to wind-load requirements that run stricter near the coast. At the estimate we tell you whether yours needs separate engineering and a separate permit, and we lay out the pool so a cage can be added later or kept in place. If an old cage is in the way of a renovation, we say so before work starts.
Permits: city or county
Inside Melbourne city limits, pool permits go through the City of Melbourne building office. A Melbourne mailing address can also sit in another city or in unincorporated Brevard County, and those go to a different office. We confirm the right one for your address during the estimate. Any permit your job needs is listed in the proposal, along with the drawings or surveys it requires.
Our pool services in Melbourne
- New Pool Construction: Custom concrete pools designed around your yard, built in stages, and paid for as the work happens.
- Pool & Spa Combinations: Attached, raised and spillover spas built with your pool, with heating sized for Florida.
- Pool Renovation: Full pool remodels: finish, tile, coping, deck and equipment, plus reshaping and new spas or sun shelves.
- Pool Features & Upgrades: Water features, LED lights, automation, fire bowls, sun shelves and more, built into new or existing pools.
- Pool Resurfacing: Plaster, quartz, pebble or glass bead interior finishes, with proper prep, start-up and curing.
- Pool Repair: Pumps, filters, heaters, salt cells, lights, leaks, cracks, tile, coping and plumbing, diagnosed and fixed.
- Weekly Pool Cleaning: A set weekly visit: skim, brush, vacuum, test, balance and check the equipment.
- Pool Leak Detection: Confirm whether your pool leaks, find the exact spot, then test again after the repair.
- Pool Equipment: Variable-speed pumps, filters, heaters, salt systems, LED lights and automation.
- Pool Tile and Coping: Waterline tile, mosaics and coping in stone, paver or brick, repaired or replaced.
- Pool Decks: New or replacement decks in pavers, travertine, marble or concrete, with proper drainage.