What does every weekly visit include?
Every visit follows the same checklist, so nothing depends on who is standing at your pool that day. We clean the surface and the floor, work the chemistry, and look over the equipment before we leave.
Same checklist, every week, means you can compare one visit to the next and see trends early. It also means a new technician on your route can pick up exactly where the last one stopped.
- Skim the surface and empty the skimmer and pump baskets
- Brush the walls, steps, benches and waterline
- Vacuum the floor when debris or algae needs it
- Test chlorine, pH, alkalinity and stabilizer, and balance as needed
- Check the pump, filter pressure, heater and salt cell if you have one
- Flag anything that needs attention before it becomes a repair
How does Florida weather change pool care?
Florida is hard on pool water because it is warm almost all year. Warm water grows algae faster and uses up chlorine faster, so summer and early fall need the closest watch.
Heavy rain is the other big factor. A summer thunderstorm can dump a lot of water into your pool in minutes, which dilutes chlorine and stabilizer and can push pH and calcium out of range. After a storm week we test first and adjust before algae gets a start.
Spring brings pollen and oak leaves. The yellow film on the surface and the leaves in the baskets are normal for this part of the state, but they feed algae and clog filters, so we skim and empty baskets more thoroughly in those weeks.
Does a screen enclosure or a salt system change the service?
Yes, a little. A screened pool catches most leaves and fewer storms reach the water, so the work leans toward chemistry and brushing. An open pool collects more debris and loses more water to evaporation, so baskets and water level get more attention.
A saltwater pool still uses chlorine. The salt cell makes it from salt in the water, so we also check the salt reading, the cell for scale buildup, and the control settings. If you are weighing the two, our guide on salt versus chlorine pools in Florida explains the tradeoffs.
What will you hear from us?
You should never have to guess what is going on with your pool. If a visit turns up something that needs your decision, like a noisy pump, a cracked light or a loose tile, we tell you.
If we find a worn pump seal, a heater that will not fire or water level dropping faster than evaporation explains, we tell you plainly and point you to the right fix. Equipment work is covered under pool equipment, and a suspected leak goes to pool leak detection.
How do we confirm your address is on a route?
Weekly service is route-based. We build routes by area so technicians are not crossing the region to reach one house, which keeps visits on a predictable day.
That is why we confirm your address is on a route before service starts. You tell us where the pool is and what kind of pool it is, we confirm the route, and then your first visit is set. Not every address fits every route, and we would rather tell you that up front.
How weekly service starts
Tell us about the pool
Call or text (689) 225-1200 with your address, pool type and whether it is screened. Photos help.
We confirm your route
We check that your address fits an existing route before service starts and tell you which day to expect us.
First visit and baseline
We clean, test and record your starting water numbers and equipment condition so we know what normal looks like.
Weekly visits
The same checklist every time: skim, brush, vacuum, test, balance and equipment check.
Early flags
We raise any repair or upgrade we notice before it becomes urgent.
Where we do this work
Weekly service runs on routes, so we confirm your address first. We cover Central Florida and the coast down to Miami, including Orlando, Winter Park, Windermere, Dr. Phillips, Lake Nona, Kissimmee, Winter Garden, Lake Mary, Clermont, Oviedo, Melbourne, Port St. Lucie, West Palm Beach, Boca Raton, Fort Lauderdale and Miami.
